You are currently viewing How to Make a Skeleton Garland for Halloween

How to Make a Skeleton Garland for Halloween

My posts may contain affiliate links. If you click though and make a purchase, we might make a small commission, but at no extra cost to you.

Need a cheap fireplace mantel decoration idea for Halloween? This Diy Halloween Garland can be made for less than $5! Let me show you How to Make a Skeleton Garland! Make sure to check out our other Fall DIYs while you’re here!

Supplies needed for this project :

  • Two skeleton garlands from the Dollar General
  • Halloween fabric fat quarter from the Dollar Tree
  • Scissors

1. Cut your fabric into strips

I started with a fat quarter and cut that in half. Then I cut snips along the long edge about 1.5 inches apart. Then just start ripping at the cut.

2. Tie the strips onto the jute

Now, you want to tie the fabric strips onto the jute that the skeletons are already hanging on using a lark’s head knot. I did two in between each skeleton and two on the outside. Two garlands were used so I just removed the skeletons from one garland and added them onto the first one.

How to make a lark’s head knot

You start by folding over your fabric strip. Place it under the jute. Insert both of your ends over the jute and into the opening of the other end. Pull the ends tight until the fabric strip is secure onto the jute.

Just keep adding the strips until you have as many as you want. And that’s it! Hang it on your mantel!

I hope you enjoyed this very simple DIY and that it inspired you to make something similar for your Halloween home decor! Make sure to join our email family to keep up with us each week! Thank you so much for visiting and God bless!

Want to Save this DIY for Later? Pin it!

Check out these other Halloween decor ideas:

This Post Has One Comment

Leave a Reply